Hoover U6049 User Manual download pdf (Page 11)

There are two belts on your cleaner. The belts drive the agitator and the

power drive pulley and are important for the efficient operation of your

cleaner. Because of this, when buying new belts, you should always insist

on genuine HOOVER belts. Some other belts on the market, not manufac-

tured under the Hoover design and quality controls, may not operate the

agitator or ‘Power Drive’ correctly and may damage your cleaner,

When to replace belts Check from time to time to be sure the belts are

in good condition. If they are stretched or cut, they should be replaced.

TO REPLACE BELTS

Remove cord from electrical outlet.

Turn cleaner over

remove metal

plate on bottom of cleaner by push-

ing latches toward the outside of

cleaner. (Fig. 1). Lift plate to release

it from clips.

There are two belts as shown in Fig.

2. The larger belt is connected to the

agitator. To remove the large belt,

push latches that hold agitator in and

toward center of cleaner until they

are free. (Fig. 2). Lift out agitator and

remove old belt. (Fig. 3).

The smaller belt is attached to the

power drive pulley. (Fig. 2). To re-

place the smaller belt, it is necessary

to first remove the larger belt. Note:

It may not be necessary to change

both belts at one time.

Place new smaller belt over power

drive pulley and motor pulley with

smooth side of belt next to pulleys.

(Fig. 2). Next, place new larger belt

over motor pulley, then over agitator.

(Fig. 3).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Hoover U6049 User Manual Page 11