Hoover S3670 User Manual download pdf (Page 12)

Service

To obtain approved HOOVER service and gen-

uine HOOVER parts, locate the nearest

Hoover Factory Service Center or

Authorized Hoover Warranty Service

Dealer (Depot) by:

• checking the Yellow Pages

under “Vacuum Cleaners -

Household” OR -

• calling 1-800-944-9200 for an

automated referral of authorized

service outlet locations (U.S. only)

OR-

• checking the Service section of Hoover,

Inc., online at www.hoover.com

Please do not send your cleaner to The

Hoover Company in Glenwillow for service, this

will only result in delay.

If further assistance is needed, contact

Hoover, Inc., Consumer Response Center,

Glenwillow, Ohio 44139, Phone:

1-800-263-6376 Mon-Fri 8AM-7PM EST.

In Canada, contact Hoover Canada,

Etobicoke, Ontario M8W 3R9, Phone:

1-800-263-6376 Mon-Fri 8AM-7PM EST.

Always identify your cleaner by the complete

model number when requesting information or

ordering parts. (The model number appears

on the bottom of the cleaner.)

Lubrication

The motor is equipped with two bearings

that contain sufficient lubrication for the life

of the motor. The addition of lubricant could

cause damage. Therefore, do not add

lubricant to either motor bearing.

The agitator brush roll is equipped with two

ball bearings that should be lubricated peri-

odically by a Hoover Factory Service Center

or an authorized Hoover Warranty Service

Dealer (Depot).

Powered hand tool

Belt replacement

Inspecting the belt

The powered hand tool belt is designed to

last a long time and is not normally replaced.

However, if the belt is cracked, gouged or

broken, it should be replaced.

12

3-27

3-28

The belt can be seen through the top of the

nozzle or by removing the bottom plate and

belt guard (Figs. 3-21 and 3-22).

2. Grasp turbine (E) and pull firmly to remove.

3. Remove belt from turbine pulley (F).

Replace with new belt.

Replacing belt

When replacing belt, ask for HOOVER part

no. 38528037.

1. Remove bottom plate, belt guard and

brush roll as described in Figs. 3-21 through

3-23.

4. With flat sides of turbine retainers (G)

pointing down, slide retainers into grooves

(H) on both sides of tool housing and snap

into place.

5. Replace brush roll, belt guard, and bottom

plate as described in Figs. 3-23 through 3-26.

F

E

G

H

3-29

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Comments to this Manuals

No comments