Hoover WindTunnel UH70200 User Manual download pdf (Page 10)

Cyclonic Filter Assembly: How to Clean

Remove dirt cup as described in Fig. 4.3.

4.9 Twist filter assembly (A) counterclockwise.

Remove assembly from dirt cup.

4.10 Dirt and debris can be cleaned from the filter

assembly with the Dusting/ Upholstery Tool.

4.11 Place the filter assembly on the dirt cup,

aligning (3) tabs (A) on filter with (3) slots on dirt cup

(B) and twist it clockwise to secure into position.

Replace dirt cup as described in Fig. 4.5.

CAUTION

! !

To reduce the risk of injury from moving parts,

unplug vacuum before servicing.

Do not use vacuum without dirt cup or filters

in place.

BRUSHROLL: How to Clean

4.12 Turn vacuum over so bottom side is facing up.

Rotate red upper latch (A) counterclockwise.

4.13 Slide red lower latch (B) to the unlock position.

4.14 Pivot out bottom plate and remove any debris

and/or hair from brushroll.

Reposition bottom plate, aligning tabs along front

edge of nozzle guard with slots in nozzle. Rotate

back into position. Slide red lower latch to Lock

position, and rotate red upper latch clockwise.

4.12

4.13

4.14

CAUTION

! !

To reduce the risk of injury from moving parts,

unplug vacuum before servicing.

4.9

4.10

4.11

Carbon Filter: What to Buy

When used and maintained properly, your

Carbon filter should not need replacement

within the warranty period. If desired,

additional filter is available. Ask for Hoover

Part No.902404001.

Carbon Filter : How to Clean

(Available on select models only).

Your Carbon Filter is located under the Filter made

with HEPA media.

IMPORTANT

DO NOT RINSE OR WASH the Carbon Filter.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 44 45

Comments to this Manuals

No comments

Hoover WindTunnel UH70200 User Manual Page 10

Comments to this Manuals

Related products and manuals for Vacuum cleaners Hoover WindTunnel UH70200