Hoover S3083-030 User Manual download pdf (Page 17)

HOW TO REPLACE THE

BOTTOM PLATE BRUSH

Disconnect cleaner from electrical outlet

and disconnect Powermatic nozzle from

extension wand.

1

Put the Surface Selector Lever in the

“Carpet” Position. This will allow for

easier removal of the brush. Turn

Power-

matic nozzle over. Remove bottom plate

by unscrewing the 2 Phillips head screws

at the back of the nozzle. Fig. 1. Lift plate

off to release from nozzle housing.

Turn inside of the bottom plate up. Care-

fully slide brush out of holders. Fig. 2.

With the Surface Selector Lever still in the

“Carpet” position, slide new brush into

holders one at a time supporting the holder

as you slide in the brush. Fig. 3. Center

brush in bottom plate opening by sliding

brush in holders as necessary.

3

Run a thin utensil such as a table knife

around the brush to make certain all the

bristles enter the slot in the bottom plate.

Fig. 4.

Replace bottom plate by fitting the plate

over the lip at the front of the nozzle hous-

ing. Line up the slots over the wheels and

position holes in bottom plate over screw

mountings. Fig. 5. Replace screws.

16

1 2 ... 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments