Hoover U8311900 Owner's Manual download pdf (Page 13)

13

Check agitator brush roll

When agitator brush roll brushes are

worn, the agitator brush roll should be

replaced.

To check condition of brushes, turn

cleaner OFF and disconnect from elec-

trical outlet.

Move edge of a card across bot-

tom plate while turning agitator

brush roll. To maintain cleaning effec-

tiveness, replace agitator brush roll if

brushes do not touch card.

40

What to buy

When purchasing a new agitator brush

roll, ask for HOOVER part no.

48414140.

How to replace

Turn cleaner ON and rotate mode con-

trol dial to HARD FLOOR. Turn cleaner

OFF and disconnect from electrical out-

let. Place handle in upright position and

turn cleaner over so bottom side is up.

Remove the five screws as shown

with a Phillips screwdriver. Lift off

bottom plate (A).

41

®®

(Cont’d) →

A

B

Agitator brush roll

Pull up on agitator brush roll (C)

to remove from brush roll cavity.

Holding agitator brush roll with

one hand, slide belt (D) off the

agitator brush roll.

43

NOTE: Hold on to the belt with one

hand. Do not allow the belt to fall back

into the cavity on bottom of cleaner.

42

Hold new agitator brush roll in

one hand; the belt in the other.

Slide the belt onto the agitator brush

roll, positioning the belt in the belt guide

(E) on the agitator brush roll.

44

C

D

E

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments