Hoover SteamVac V2 User Manual download pdf (Page 11)

11

Continued ➜

Cleaning bare floors

3-9

How to attach bare floor

attachment

(Available at additional cost if not includ-

ed with your cleaner.)

Unplug deep cleaner from electrical

outlet.

To prevent possible leaking, remove

clean water tank (Fig. 2-10) and recov-

ery tank (Fig. 2-16) before positioning

bare floor attachment.

Set tanks aside (do not set tank on furni-

ture).

1. With handle in upright position, tilt

cleaner back so that handle rests on the

floor.

2. With foam strip (C) (located under the

netting) in position as shown, place

attachment on front of nozzle (D).

Make sure arrow on end of attachment

points in the direction as shown.

3. Push attachment against nozzle while

rotating attachment downward until both

ends snap into place.

(Note: Some force may be required to

rotate and snap attachment into place.)

4. Return deep cleaner to upright posi-

tion. Lower handle and replace recovery

tank.

5. Raise handle to upright position and

reposition clean water tank.

3-8

C

D

E

F

To clean floor

Read “Before you begin cleaning”

instructions on page 9.

Do not use the deep cleaner on hard-

wood floors.

1. Fill clean water tank according to

instructions for Figs. 2-9 to 2-15.

2. Fill detergent container with HOOVER

Bare Floor Cleaner according to instruc-

tions for Figs. 2-13 to 2-15.

3. Turn brushes ON for scrubbing or

OFF if scrubbing is not desired.

4. Dry hands and plug deep cleaner

into a properly grounded outlet.

5. Step on handle release pedal and

lower handle to operating position.

6. Set Wash/Rinse switch to WASH. Turn

cleaner ON.

7. To release solution, press trigger.

Slowly move deep cleaner forward and

backward over area to be cleaned.

8. To pick up dirty solution, release trig-

ger and slowly move deep cleaner over

area where solution has just been dis-

persed. Use both forward and reverse

strokes.

9. If rinsing the floor is desired, set

Wash/Rinse switch to RINSE. Repeat

steps 7 & 8.

Rinsing is not necessary, but will help

remove detergent residue from the floor.

10. Empty recovery tank when the

motor sound becomes higher pitched

and there is a loss in suction (see

“Automatic shut-off”, Fig. 2-6).

11. When finished cleaning, follow “After

cleaning” instructions on pages 9 & 10.

Unplug deep cleaner from electrical

outlet and remove attachment from noz-

zle. Rinse it in clear water. Do not

remove plastic screen or foam from

attachment.

3-10

3-11 3-12

Using the tools

Attach hose

Unplug cleaner from electrical outlet.

Open hose connection port (E).

Insert short hose end. Twist hose end to

lock in place.

Plug solution tube firmly into solution

connection port (F).

1 ... 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments