Hoover Vacuum Cleaners User Manual download pdf (Page 18)

3. Note position of bar-brush as-

semblies to insure correct replace-

ment.

Remove bar-brush

zjlssemblies

pulling them from agitator slots.

Use pliers if necessary.

The word “BAR” is stamped near

the slots on the agitator.

Match the bar side of the bar

brush assembly with the label on

the agitator shell. Slide the new

assemblies into the slots, while

twisting the assemblies in a coun-

terclockwise motion. Push in as

far as possible, tapping the other

end lightly if necessary. Be sure

brushes and bars are aligned for

full length of agitator.

4. Reassemble agitator parts. Line

up locator on end sections with

slot on agitator. Push end sections

into position.

Screw on end plates and tighten.

5. Should you accidentally dis-

place the bearing during dis-

assembly, reassemble as shown.

Replace belt, agitator and nozzle

cover.

END SECTION

Lubrication

The motor is equipped with two bearings that contain sufficient lubrication

for the life of the motor. The addition of lubricant could cause damage.

Therefore, do not add lubricant to either motor bearing.

The agitator is equipped with two ball bearings that should be lubricated

periodically. This should be done by a Hoover Factory Service Center or an

Authorized Hoover Warranty Service Dealer.

1 2 ... 13 14 15 16 17 18 19 20

No comments

Hoover Vacuum Cleaners User Manual Page 18