Hoover Self-Propelled WindTunnel Bagless with Powered Han User Manual download pdf (Page 9)

9

3-14

3-15

3-16

Headlight replacement

What to buy

This cleaner uses a 12 volt, wedge base

type 912 bulb, Hoover part No. 27313101.

Reattaching filter door

The filter door is designed with a

“break-away” feature which allows it to

snap free if it is pushed open too far.

To reattach, align hinges (O) of cover

with slots on sides of filter area.

Press door back into place.

Check brush roll

channels

Because your cleaner picks up so well,

we strongly recommend you check for

debris accumulation in the channels

next to the brush roll when you check

the filters. Removing this debris will

help maintain your cleaner’s excellent

pick up and suction. Remove debris as

follows:

Disconnect cleaner from electrical

outlet.

Check for debris accumulation by

removing bottom plate (Fig. 3-18) and

looking in the channels next to the brush

roll (Fig. 3-27).

Remove any accumulation.

Reposition bottom plate (Fig. 3-22).

3-10

3-11

3-12

M

L

To re-assemble filter assembly, place

large knob of HEPA cartridge filter in

hole on bottom of pre-filter.

Snap top of HEPA cartridge filter into

place.

Align grooves (L) on pre-filter frame with

ribs (M) in dirt cup.

Slide filter assembly down into cup until

a light snap is felt. Gently pull up on

assembly to ensure that it is seated

properly in the cup. Ensure that no part

of pre-filter screen extends above top

edge of dirt cup.

Close lid and return cup to cleaner (Fig.

3-5).

Note: If dirt cup lid does not close all

the way, first ensure that filter assembly

is pushed down all the way. Then, turn

knob on lid slightly until lid closes (see

Fig. 3-3).

3-13

N

O

Final filter

Replacing final filter

The final filter assists in the filtration

process to return clean air to the room.

To replace this filter when it becomes

dirty, open the door on the side of the

cleaner. Remove filter (N) and discard.

Reposition new filter on the side of

cleaner. Make sure the white side of the

filter faces outward. Close door.

Should you want to replace this filter,

ask for part No. 40110006.

Do not operate cleaner without the fil-

ter in place.

Removing lens

Disconnect cleaner from electrical

outlet.

Using a screwdriver, remove the two

screws as shown and lift off lens.

Installing bulb

Pull old bulb straight out of socket. Push

new bulb straight into socket until locked

in place

Excessive force is not required.

Replacing lens

Reposition lens and secure with the two

screws.

Continued

3-17

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments